After processing the cloth, introduce the cloth guide to the operating table , tear off the cloth guide , click the main cloth feed control button to red , and turn off the upper needle protection entry button to " {{0}} ". Start the second half of the machine, and stop when the cloth guide head reaches the cloth overfeeding roller, connect the cloth guide with the belt, turn off the cooling drum tension motor to " 0 " and start the second half of the machine until the cloth guide is completely out of the cloth rack and stop. Turn off the main cloth output control button to red, and start the machine to let the chain run idly.
Click the oven button to enter the heating system interface, set the heating temperature to 150 degrees, the circulating fan power is 50 percent , the exhaust fan is manually controlled and the air is drawn at 100 percent power, which can effectively remove the residual moisture in the oven, thereby maintaining the oven effect. Turn off the heating system after running for about 30 minutes, let the circulating fan and exhaust fan continue to run until the temperature in the oven drops below 100 degrees, then turn off.
Turn off the main control switch of the power supply of the power-off cabinet to " OFF ", the computer will automatically store the processing data and then turn it off to clean the whole machine. This is the data of the domestic CY200 hot air stenter setting machine: ◆ Car type: left-handed car (or right-handed car) ◆ Overfeeding : positive overfeeding 30 percent , negative overfeeding less than 10 percent . ◆ Vehicle speed: 10-100m/min. ◆ Installed power: about 120kw ◆ Heat source and consumption: circulating heat conduction oil consumption 3.344x106KJ/h. ◆ Drying room size: (length x width x height) ◆ Drying room working temperature: 160- 220 degree , automatic temperature control ( 690 plus 2910xN ) X (2200 plus W)x1700 (N is the number of drying room sections ) ◆ Amplitude modulation range: 700-- ( W-50 ) mm ◆ Full machine size: (length x width x height) ) ◆ Cloth feeding method: horizontal movement of needle plate or cloth clip. ( 14458 plus 2910xN ) X(2500 plus W)x3200 (N is the number of drying room sections ) ◆ Cloth discharging method: pendulum folding cloth or large roll cloth dropping. ◆ Machine weight: about 40t ( width 2200.7 knots drying room ) ◆ Transmission mode: AC motor driven by variable current and frequency conversion speed.
https://www.sunwinmachinery.com/
